Remove excess water with the paper towel. A glass slide is a thin, flat, rectangular piece of glass that is used as a platform for microscopic specimen observation. A typical glass slide usually measures 25 mm wide by 75 mm, or 1 inch by 3 inches long, and is designed to fit under the stage clips on a microscope stage. Place a sample on the slide. Using a pipette, place a drop of water on the specimen. Then place on edge of the cover slip over the sample and carefully lower the cover slip into place using a toothpick or equivalent.
This method will help prevent air bubbles from being trapped under the cover slip. A dry mount is exactly as it sounds: the thing you plan to observe is placed on the slide with a cover slip over it. No water is needed. This kind of mount is usually used for inanimate objects or things that do not need water to live.
What would indicate you are observing an air bubble rather than an organism through the microscope? It is perfectly round and may be shiny. To avoid bubbles : Clear bubbles from the tip of your applicator i. Clean the surface of the non-sample side of the coverslip prior to imaging. What is the value of a wet - mount preparation in the clinical laboratory?
The value of a wet - mount prep in the clinical lab is being able to see a living specimen and look for motility, which aids in identity of the organism. Here is the procedure for aking a wet mount slide of a letter.
Use the eyedropper to place a drop of water on the center of a microscope slide. Use the tweezers to position the letter "e" in the center of the drop.
Place a piece of napkin or paper towel against the opposite side of your cover slip, right up against the edge. This will help draw the stain under the cover and across the specimen. Slide Mount Instructions. Dry Mount In a dry mount, the specimen is placed directly on the slide.
Wet Mount In a wet mount, a drop of water is used to suspend the specimen between the slide and cover slip. Section Mount In a section mount, an extremely thin cross-section of a specimen is used. Smear A smear is made by carefully smearing a thin layer of the specimen across a slide and then applying a cover slip.
Stain Types. Iodine is one of the more commonly available stains and is used to identify starch in a variety of samples. It will stain carbohydrates in plants and animal specimens brown or blue-black. Glycogen will sh ow as red. Gram's Stain is one of the most frequently used processes in identifying bacteria — used daily in hospitals. It is a primary test that quickly and cost effectively divides bacteria into one of two types: Gram positive or Gram negative.
Prepare a wet mount slide. Collect a drop of stain with an eye dropper or pipette. Why are coverslips made of glass? Which objective lens do you use first? Are coverslips necessary? How thick is a cover slip? What is the advantage of using a wet mount? Why is it important to put a cover slip over a drop of water when you prepare a wet mount?
Why is water important in doing a wet mount? What is the disadvantage in preparing a wet mount? What precautions should be taken when preparing a wet mount? What is the advantage of using a wet mount quizlet? What is the difference between a wet mount and a prepared slide? What types of organisms can be viewed on a wet mount? What lens would get dirty with oil if you move the revolving? What is the hanging drop method used for? If a stain or other liquid has been added, the cover slip keeps it on the specimen.
Cover slips also protect the specimens from contamination by airborne particles or other substances. A prepared slide that is made up of a microscope slide, specimen and a cover slip not only gives the viewer better control over the specimen, but protects the microscope as well. The cover slip protects the ocular lens from damage by acting as a barrier between it and the specimen. The slide itself also helps to keep the stage, or the part of the microscope below the lens, clean.
How to Label a Binocular Microscope. Simple Microscope Experiments.
0コメント